Optional Accessories - Makita CL117FD Instruction Manual

Disposing cleaner
A Li-ion battery is built in this cleaner. Always remove it
before disposing of the cleaner.
Removing built-in battery
CAUTION:
Do not touch the terminals with
any conductive material.
CAUTION:
Avoid storing battery unit in a
container with other metal objects such as nails,
coins, etc.
CAUTION:
Do not expose battery unit to
water or rain.
CAUTION:
Do not disassemble or alter bat-
tery unit.
CAUTION:
The cleaner must be disconnected
from the supply mains when removing the battery.
CAUTION:
Hold the appliance and battery unit
firmly when removing and installing the battery
unit. Failure to do so may cause them to slip off your
hands, resulting in damage to the appliance and
battery unit and personal injury.
CAUTION:
Take care not to trap finger(s)
between the cleaner, rear cover and battery when
removing and installing the battery unit. Trapping
finger(s) may cause injury.
1. To remove the rear cover, push it in the direction of
the arrow.
► Fig.40: 1. Rear cover
2.
Slide the built-in battery halfway. Disconnect the
lead wires from the battery by slightly moving back the
battery while pressing the connector in the direction of
arrow as shown in the figure.
► Fig.41: 1. Connector 2. Lead wires
3. Then slide the battery unit out completely.
► Fig.42: 1. Battery unit
4.
Put the removed battery unit in a carton box so
that it is not circuit-shorted.
Installing replacement battery
To install the replacement battery, follow the removal
procedure in reverse.
CAUTION:
Route the lead so that it is com-
pletely stored inside the cleaner before putting
the rear cover back in the original position. Failure
to do this may damage the lead.
► Fig.43
After installing the battery (see "SPECIFICATIONS"),
charge the battery before use.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita appli-
ance specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Extension wand
• Nozzle
• Nozzle for carpet
• Shelf brush
• Corner nozzle
• Round brush
• Flexible hose
• Filter
• Prefilter
• High performance filter
• HEPA filter
• Seat nozzle
• Crevice nozzle
• Wall mount for cordless cleaner
• Cyclone attachment
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
appliance package as standard accessories. They
may differ from country to country.
Cyclone attachment
► Fig.44: 1. Release button 2. Hook 3. Extension
wand 4. Cyclone attachment 5. Suction inlet
About the cyclone attachment
Using the cleaner with the cyclone attachment installed
reduces the amount of dust that enters the capsule,
which helps to prevent the suction force from weaken-
ing. In addition, cleaning after use is also simple.
CAUTION:
Always be sure that the appliance
is switched off before carrying out any work on
the appliance.
CAUTION:
Clean the mesh filter of the
cyclone attachment and the filters of the cleaner
unit when they become clogged. Continued use in
the clogged condition may result in heating or smoke.
16 ENGLISH