Table of Contents
Advertisement
Preparation
The mouse function of the remote control
With the built-in gyroscope sensor, setup the TV
through motion sensing of the remote control .
With the mouse function, you can move the cursor
on the screen to selected item and press OK to enter
when browsing the smart home.
• When the remote control is in dormancy,flick the remote
control to restart it.
The operation button
You can also setup the TV through the operation
button at the TV back. (The position of operation
button, please see page 12)
Action
Short press
Turn on the TV.
Left/Right
Set the volume reduction/add.
Up/Down
Set the channel up/down.
Long press
Display the menu (Pairing, Power off )
when the TV is switched on.
14
Description
Remote control pairing
The remote control unit has been pre-paired with the
TV set in factory so you can use the remote control
unit directly. If the remote control fails to operate or
a new remote control unit is used, please follow the
following steps to pair the remote control unit and the
TV.
Press the "
" button on the TV for a few
1
seconds, "Pairing "and " Power off " menu will
be displayed.
Use the operation button on the TV to choose
2
"Pairing" and then press the TV operation
button.
Point the remote control unit towards the
3
bottom of
TV (
near
SHARP
press "OK" and "
" at the same time until red
and blue lights stop flashing alternately .
Press "OK" on the remote control unit to
4
complete the Bluetooth pairing .
NOTE
• If the TV does not display the remote control pairing
information, the "Pairing" Interface will be displayed
automatically. Press OK &
(POWER) on the remote
control unit at the same time, the red and blue lights
flash alternately. Once the flashing stop, press OK to
complete the Bluetooth pairing.
• If pairing is not succeed, please try again or contact the
customer service center.
trademark),
Advertisement
Chapters
Table of Contents
