Setting Up; Battery Low Warning - AEG Elegant User Manual

4.

Setting up

- Connect the base
1. Plug the mains power cable into the socket marked
of the base and plug the other end into the mains power wall socket and
switch the power on.
The telephone cable is pre-installed in the base but do not connect the
other end to the telephone wall socket yet.
2. Rechargeable batteries are already fitted in your handset. To activate
the batteries, pull the plastic tab away from the bottom of the handset as
shown on the label provided.
3. Place the handset on the base to charge for at least 24 hours. The red
charging light comes on. When the handset is fully charged the display
shows the
4. After 24 hours, plug the telephone line cord from the base into the
telephone wall socket.
- Setting up for multiple packs
If you have purchased a multiple pack, this process will need to be carried out
for all handsets and chargers:
1. Plug the mains power cable into the socket marked
the charger.
2. Activate the batteries as described previously above.
3. Place the handset on the charger to charge for at least 24 hours. When the
handset is fully charged the
Your Elegant is ready for use.
5.

Battery low warning

If the icon flashes in the external display you will need to recharge the
handset before you can use it again.
During charging, the
icon.
icon will scroll in the display.
icon will indicate that it is fully charged.
7
on the underside
on the underside of