Operation - Makita XRU15PT Instruction Manual

Installing the protector
WARNING:
Never use the tool without the
guard illustrated in place. Failure to do so can
cause serious personal injury.
CAUTION:
Take care not to injure yourself on
the cutter for cutting the nylon cord.
Attach the protector to the clamp using bolts.
2
► 1. Clamp 2. Protector 3. Cutter
Installing the cutting tool
CAUTION:
Always use the supplied
wrench(es) to remove or to install the cutting tool.
CAUTION:
Be sure to remove the hex wrench
inserted into the tool head after installing the cutting tool.
NOTE: The type of the cutting tool(s) supplied as the standard
accessory varies depending on the countires. The cutting tool
is not included in some specifications of the model.
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.
NOTICE:
Be sure to use genuine Makita nylon
cutting head.
6
5
2
3
► 1. Nylon cutting head 2. Receive washer 3. Spindle
4. Hex wrench 5. Tighten 6. Loosen
1. Insert the hex wrench through the hole in the tool
head to lock the shaft. Rotate the shaft until the hex
wrench is fully inserted.
2.
tighten it securely by hand.
3.
To remove the nylon cutting head, follow the installation
procedures in reverse.
1
1.
3
2.
hanger.
1
4
► 1. Hook 2. Hanger
12 ENGLISH
Place the nylon cutting head onto the spindle and
Remove the hex wrench from the tool head.

OPERATION

Attaching the shoulder harness
CAUTION:
Always use the shoulder harness
attached to the tool. Before operation, adjust the
shoulder harness according to the user size to
prevent fatigue.
CAUTION:
Before operation, make sure that
the shoulder harness is properly attached to the
hanger on the tool.
Wear the shoulder harness on your left shoulder.
Clasp the hook on the shoulder strap to tool's
2
1