Audience; Organization - Cisco SCE 1000 2xGBE Installation And Configuration Manual

Audience

D
ESCRIPTION OF
Complete reorganization and revision of product documentation.
Audience
This guide is for the networking or computer technician responsible for installing and configuring
the SCE 1000 platform on-site. To use this publication, you should be familiar with
telecommunications equipment and installation procedures, as well as electronic circuitry and
wiring practices. You should also have experience as an electronic or electromechanical
technician.
This installation guide explains the initial hardware installation and basic configuration
procedures for the SCE 1000. It contains procedures for unpacking and installing the device and
performing basic configuration via the setup wizard. After completing the installation and basic
configuration procedures covered in this guide, you will then use the appropriate companion
publications to more completely configure your system.
This guide contains instructions on how to install and run the SCE 1000 platform. This guide
assumes a basic familiarity with telecommunications equipment and installation procedures.

Organization

The major sections of this guide are as follows:
Chapter
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Cisco SCE 1000 2xGBE Installation and Configuration Guide
viii
C
HANGES
Title
Overview (on page 1-1)
Introduction to the SCE
Platform (on page 2-1)
Topology (on page 3-1)
Installation and
Maintenance (on page 4-
1)
Connecting the
Management Interfaces
and Performing Initial
System Configuration
Cabling the Line Ports
and Completing the
Installation (on page 6-1)
Basic SCE 1000 Platform
Operations (on page 7-1)
Troubleshooting (on page
8-1)
Description
This chapter provides a brief introduction to Cisco Service
Control.
This chapter provides a hardware overview of the SCE
1000 platform.
This chapter describes the possible deployment topologies
of the SCE 1000 and explains how various aspects of the
topology determine the configuration of the system.
This chapter explains how to install a SCE 1000 platform
in a rack or in a general tabletop installation and how to
install or replace the power supply units and fan modules.
This chapter explains how to connect the SCE 1000
platform to a local console and perform the initial system
configuration via the setup wizard that runs automatically.
This chapter provides instructions for cabling the Gigabit
Ethernet ports for one SCE 1000 topologies and for
configuring Gigabit Ethernet (GBE) interface parameters.
This chapter describes how to start up the SCE 1000
platform, reboot, and shutdown. It also describes how to
manage configurations.
This chapter provides basic system startup troubleshooting
information.
Preface
OL-7821-05