Table of Contents
Advertisement
20
LUBRICATION SYSTEM
Changing the engine oil and oil filter, cleaning the oil screen
Warning
Danger of scalding
-
Wear suitable protective clothing and safety gloves.
-
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Environmental hazard
-
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
Drain the engine oil only when the engine is warm.
If the engine oil does not reach the middle of level viewer 6):
-
Engine and gear oil get very hot when the motorcycle is ridden.
Hazardous substances cause environmental damage.
Preparatory work
-
Park the motorcycle on a level surface.
Main work
-
Place a suitable container under the engine.
Remove oil drain plug
Info
Do not remove screws
-
Remove screw plug
-
Completely drain the engine oil.
-
Thoroughly clean the parts and sealing surfaces.
-
Position oil screen
-
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
-
Push the oil screen all the way into the engine case.
-
Mount and tighten screw plug
I
Guideline
Screw plug, oil screen
-
Mount and tighten oil drain plug
I
Guideline
Oil drain plug with magnet
Add engine oil.
(a
p. 191)
O
with the magnet and seal ring.
8
on both sides.
CD
with oil screen
8
with the O-rings on a pin wrench.
CD
with the O-ring.
O
with the magnet and a new seal ring.
e.
I
M20x1 .5
15 Nm (11.1 lbf ft)
I
I
M12x1.5
20 Nm (14.8 lbf ft)
189
I
Advertisement
Table of Contents
