Maintenance Procedures For The Cisco 7505; Removing And Replacing The Cisco 7505 Cover Panel - Cisco 7500 Series Configuration Manual

Chapter 5 Maintaining Your Cisco 7505 Router

Maintenance Procedures for the Cisco 7505

The specific maintenance procedures for your Cisco 7505 router are described in the following sections:
•
•
•
•
•
•
Warning Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.

Removing and Replacing the Cisco 7505 Cover Panel

The two captive slotted screws are the only fasteners on the cover panel. Five shallow tabs at the bottom
edge of the panel fit into slots at the base of the chassis opening. The tabs act as a pivot point for pulling
the top of the panel away from the chassis opening, and as guides to align the panel when replacing it.
If the chassis cover does not seal the end of the chassis, the flow of cooling air inside the chassis can be
misrouted, which can result in an overtemperature condition.
Warning Before working on the chassis or near power supplies, disconnect the power cable on AC units or
disconnect the power at the circuit breaker on DC units.
OL-5008-03 B0
Removing and Replacing the Cisco 7505 Cover Panel, page 5-3
Removing and Replacing the Cisco 7505 Fan Tray, page 5-5
Removing and Replacing the Cisco 7505 Power Harness Cover, page 5-7
Removing and Replacing the Cisco 7505 Backplane Cover, page 5-9
Removing and Replacing the Chassis Interface in the Cisco 7505, page 5-11
Removing and Replacing the Cisco 7505 Power Supply, page 5-13
Maintenance Procedures for the Cisco 7505
Cisco 7500 Series Installation and Configuration Guide
5-3