Cisco 7500 Series Configuration Manual page 158

Recovering a Lost Password
enable "load rom after netbootfails"? y/n [n]:
enable "use all zero broadcast"? y/n [n]:
enable "break/abort has effect?" y/n [n]:
enable "ignore system config info?" [n]: y
change console baud rate? y/n [n]:
change boot characteristics? y/n [n]
Configuration Summary
enabled are:
console baud: 9600
boot: image specified by the boot system command
or default to: cisco2-RSP
do you wish to change the configuration? y/n [n]
You must reset or power cycle for the new config to take effect
Initialize the router by entering the i command as follows:
Step 7
rommon 1> i
The router will power cycle, the configuration register will be set to ignore the configuration file, and
the router will boot the boot system image and prompt you with the system configuration dialog as
follows:
--- System Configuration Dialog ---
Step 8 Enter no in response to the system configuration dialog prompts until the following system message is
displayed:
Press RETURN to get started!
Step 9 Press Return. After some interface information displays, the prompt appears as follows:
Router>
Step 10 Enter the enable command to enter enabled mode. The prompt changes to the following:
Router#
Enter the show configuration EXEC command to display the enable password in the configuration file.
Step 11
Enter the configure terminal command at the EXEC prompt. You are prompted as follows:
Step 12
Router# configure terminal
Enter configuration commands, one per line.
Router(config)#
Change the configuration register value back to its original value (noted from Step 3) or change it to a
Step 13
value of 0x0101 (factory default) using the config-register 0x value command.
Exit configuration mode by entering Ctrl-Z.
Step 14
Step 15 Reboot the router and enable it using the recovered password.
This completes the procedure for recovering a lost password.
Cisco 7500 Series Installation and Configuration Guide
4-10
Chapter 4 Performing a Basic Configuration of the System
End with CNTL/Z.
OL-5008-03 B0