Installing The Cisco 7507 And Cisco 7507-Mx - Cisco 7500 Series Configuration Manual

Chapter 3 Installing a Cisco 7500 Series Router
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
This completes the procedure for attaching DC-input cables to the Cisco 7505 DC-input power supply,
as well as procedures required to install the Cisco 7505.
For information on how to connect cables to the RSP, see the
section on page

Installing the Cisco 7507 and Cisco 7507-MX

This section provides procedures for installing your Cisco 7507 and Cisco 7507-MX and for connecting
power cables to power supplies.
or Cisco 7507-MX router and connect cables. It also indicates the Cisco publications you should refer
to for more detailed information.
Figure 3-7
create a basic configuration file. Use the
For more information about configuration,
Depending on your configuration, you might need to insert additional or new processor modules in your
Cisco 7507 or Cisco 7507-MX. To insert or remove interface processors, you do not need to turn off
power to the system. However, if the system is operating, you must turn off the system power before you
insert or remove an RSP2, RSP4, or RSP8.
You need a number 1 Phillips or 3/16-inch flat-blade screwdriver to remove any fillers (blank processor
module carriers) and to tighten the captive installation screws that secure the processor module in its slot.
Whenever you handle modules, you should use an ESD-preventive wrist strap or other grounding device
to prevent ESD damage.
OL-5008-03 B0
3-32, and then proceed to the
Installation Flowchart (Cisco 7507 and Cisco 7507-MX)
Unpack the router
(Use Cisco 7000 and Cisco 7507
Unpacking Instructions)
Rack-mount the router
(Use Cisco 7000 and Cisco 7507
Rack-Mount Installation Instructions)
Insert power supplies
Make external connections
Perform an initial configuration and
procedures in Chapter 4 "Performing
a Basic Configuration of the System."
refer to the Cisco IOS configuration
guides and command references.
"What Do I Do Now?" section on page
Figure 3-7 illustrates the order of procedures to install the Cisco 7507
Cisco 7500 Series Installation and Configuration Guide
Installing the Cisco 7507 and Cisco 7507-MX
"Making Cable Connections to the RSP"
3-33.
3-11