Configuring Interfaces - Cisco 7500 Series Configuration Manual

Chapter 4 Performing a Basic Configuration of the System
instead of the enable password when it exists.
Enter enable secret: barney
The enable password is used when there is no enable secret
and when using older software and some boot images.
Enter enable password: betty
Enter virtual terminal password: fred
Configure SNMP Network Management? [yes]:
Configure AppleTalk? [no]: y
Configure CLNS? [no]:
Configure IPX? [no]:
Configure Vines? [no]:
Configure XNS? [no]:
Configure DECnet? [no]:
Configure CLNS? [no]:
Configure bridging? [no]:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Configure Apollo? [no]:
Step 11 Save your settings to NVRAM. (For more information on saving settings to NVRAM, see the
the Settings to NVRAM and Reviewing Your Configuration" section on page

Configuring Interfaces

This section provides procedures for configuring interfaces to allow communication over a LAN or
WAN. To configure the interface parameters, you will need your interface network addresses and subnet
mask information; consult your network administrator for this information.
Configuring an Ethernet Interface
Use the following procedure to configure an Ethernet interface:
Step 1 In the following example, the system is being configured for an Ethernet LAN using IP. Respond as
follows to the setup prompts, using your own addresses and mask:
Configuring interface parameters:
Configuring interface Ethernet0/0:
Is this interface in use? [no]: yes
Configure IP on this interface? [no]: yes
Step 2 Determine if you are going to enable IPX on this interface. If yes, enter the unique IPX network number:
Configure IPX on this interface? [no]: yes
Enter yes if you want to use AppleTalk on the interface; enter yes to configure for extended AppleTalk
Step 3
networks, and then enter the cable range number and the zone name that is to be associated with your
local zone:
Configure appletalk on this interface? [no]: yes
OL-5008-03 B0
Your IGRP autonomous system number [15]:
IP address for this interface: 10.1.1.10
Number of bits in subnet field [0]:
Class A network is 10.0.0.0, 0 subnet bits; mask is 255.0.0.0
IPX network number [2]:
Configuring the Cisco 7500 Series System
Cisco 7500 Series Installation and Configuration Guide
"Saving
4-19.)
4-15