Set-Th-Env; Table 9-53 Set-Th-Env Syntax Description - Cisco 15216 EDFA2 Operation Manual

TL1 Commands and Autonomous Messages
Table 9-52 SET-TH-DWDM Syntax Description (continued)
Parameter
threshholdtype
and
thresholdvalue
pairs

9.7.46 SET-TH-ENV

Command
SET-TH-ENV
Sets threshold values of the environmental (power bus) parameters of the ONS 15216 EDFA2.
Syntax
SET-TH-ENV:[<tid>]:<aid>:<ctag>::<thresholdtype>,<thresholdvalue>[,,];
Example 9-49 SET-TH-ENV Command
Amp01:ONS15216 EDFA2> SET-TH-ENV:Amp01:PWR-A:100::PWRBUSMIN,450;

Table 9-53 SET-TH-ENV Syntax Description

Parameter
aid
Cisco ONS 15216 EDFA2 Operations Guide
9-62
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Syntax
string
LOSHYST
LOSTH
LPOUTDEV
LPOUTHYST
Syntax
PWR-A
PWR-B
ALL
Description
Type of threshold that is to be set. The threshold is set to the
thresholdvalue that follows the comma. Possible to specify
values for one or more of the following:
Loss of signal (input power) hysteresis
(cerent15216EdfaLOSHysteresis).
thresholdvalue can be between 0 and 1000, with default of
100, in units of 100 dB.
Loss of signal (input power) threshold
(cerent15216EdfaLOSThreshold).
thresholdvalue can be between –3100 and –1500, with
default of –3000, in units of 100 dBm.
Loss of output power deviation
(cerent15216EdfaLpoutDeviation).
thresholdvalue can be between 0 and 1000, with default of
200, in units of 100 dB.
Loss of output power hysteresis
(cerent15216EdfaLpoutHysteresis).
thresholdvalue can be between 0 and 1000, with default of
100, in units of 100 dB.
Description
PWR-A, PWR-B, and ALL have same input effect.
Sets Power Bus A and Power Bus B.
Sets Power Bus A and Power Bus B.
Any or all of the preceding (command input only).
Chapter 9 TL1 Commands
78-16033-01