Apply - Cisco 15216 EDFA2 Operation Manual

Chapter 9 TL1 Commands
Table 9-10 ALW-MSG-ALL Syntax Description (continued)
Parameter

9.7.3 APPLY

Command APPLY
Applies a software cutover in the memory. There are two boot file entries. This command exchanges boot
file entries 1 and 2 so that when the system is restarted (by the INIT-SYS command), it boots with the
image that was (before the execution of this command) at the second entry.
78-16033-01
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Syntax
GAINCHGD
LOSHYSTCHGD
LOSTHCHGD
LPOUTCHGD
LPOUTDEVCHGD
LPOUTHYSTCHGD
PREATTCHGD
PWRBUSMAXCHGD
PWRBUSMINCHGD
PWRBUSMODE
MAXCTMPCHGD
MAXCTMPHYSTCHGD "Max Ctmp (case temperature) Hysteresis Changed"
MINCTMPCHGD
MINCTMPHYSTCHGD
CUTOVERRESET
SOFTWARELOAD
SOFTWARERESET
ALL
TL1 Commands and Autonomous Messages
Description
"Overall Gain Changed"
(cerent15216EdfaConstGainOverallGain).
"LOS (loss of signal) Hysteresis Changed"
(cerent15216EdfaLOSHysteresis).
"LOS (loss of signal) Threshold Changed"
(cerent15216EdfaLOSThreshold).
"Loss of Output Power Setpoint Changed"
(cerent15216EdfaLpoutSetpoint).
"Lpout (loss of output power) Deviation Changed"
(cerent15216EdfaLpoutDeviation).
"Lpout (loss of output power) Hysteresis Changed"
(cerent15216EdfaLpoutHysteresis).
"Pre-attenuation Changed"
(cerent15216EdfaVariableGainPreAttenuation).
"Power Bus Max (voltage) Changed"
(cerent15216EdfaPowerBusDCVoltageMax).
"Power Bus Min (voltage) Changed"
(cerent15216EdfaPowerBusDCVoltageMin).
"Power Bus Mode Changed"
(cerent15216EdfaPowerBusMode).
"Max Case Temperature Changed"
(cerent15216EdfaCtmpMax).
(cerent15216EdfaCtmpMaxHysteresis).
"Min Case Temperature Changed"
(cerent15216EdfaCtmpMin).
"Min Ctmp (case temperature) Hysteresis Changed"
(cerent15216EdfaCtmpMinHysteresis).
(Software) "Reset after Cutover"
(cerent15216EdfaOpCutover).
(New) "Software Load" (cerent15216EdfaOpLoad).
"Software Reset" (cerent15216EdfaOpReset).
All condtype preceding.
Cisco ONS 15216 EDFA2 Operations Guide
9-11