Required Tools And Equipment; Attaching The Center-Mount Brackets To The Chassis - Cisco 3640 Installation Manual

Required Tools and Equipment

You need the following tools and equipment to install the center-mount brackets:
•
•

Attaching the Center-Mount Brackets to the Chassis

You can use the center mount brackets to install the Cisco 3640 chassis with either the front panel or the
rear panel facing forward. The bracket orientation and attachment holes used are different for
front-facing and rear-facing installations.
Complete the applicable procedure below, depending on the required chassis orientation in the rack.
Front-Panel Forward Installation
Attach one bracket to each side of the Cisco 3640 chassis as shown in Figure 1.
•
•
•
Figure 1
The second bracket attaches to the other side of the chassis.
Use holes numbered 1 for front-panel forward.
78-11336-01
Number 2 Phillips screwdriver
Screws for rack mounting
Position the angled end of the bracket flush with the rear of the chassis.
Insert the four screws at the rear into the bracket holes numbered "1."
Insert the two screws at the front into the two lined-up holes.
Bracket Attachment with Front Panel Facing Forward
0 1 2 3
ACTIV E
READ Y
PCM CIA
1
0
Center-Mount Bracket Installation Guide for Cisco 3640 Routers
Required Tools and Equipment
2
1
2
1
5