Replacing The Guide Bar Bolt - Makita EA6100P Repair Manual

03 CHAIN BRAKE / GUIDE BAR BOLT
Remove the circlip 6.
Pull the disengagement mechanism up in
parallel with the axes.
Pull off the handguard with gentle back-and-
forth motion.
Note: When reassembling always use a new
circlip 6 (927.304.000)!
Repair Manual EA6100P / EA6101P
7
6
ca. 5 mm
Note: Make sure that the handguard guide
7 is not unhooked. If necessary, push it back
into position with a screwdriver (about 5 mm
from the axle support). The handguard can
only be assembled when the rest piece is in
this position.
Assemble the handguard and disengagement
mechanism, brake band and brake band
spring in reverse order.

Replacing the guide bar bolt

Screw two nuts onto the bar bolt and
counterlock them.
Unscrew the bar bolt.
Assembly: Apply Loctite 243 (980.009.000) to
the guide bar bolts and turn them all the way
in.
9