07 IGNITION SYSTEM
Removing the ywheel
Remove the starting system, see chapter 06.
Block the piston, see chapter 04.
Loosen the nut in the direction of the arrow
and remove it along with the washer.
Repair Manual EA6100P / EA6101P
Screw the disassembly mandrel (chap. 00,
Pos. 2) onto the threaded end of the shaft.
Do not screw the mandrel all the way down.
Leave about 2 mm between the mandrel and
the ywheel.
Hold the machine in one hand and knock the
ywheel loose with a tap on the mandrel.
CAUTION: The cone of the crankshaft must
always be degreased before assembly.
Nut tightening torque: 28
Nm
+/-2.0
Starting ratchets
Check the starter pawls on the ywheel for
easy movement, and clean if necessary.
Install spring as illustrated.
Screw tightening torque: 8
+/-1.0
Nm.
17