04 CLUTCH
Inserting the yweights
Hook the springs as shown in the illustration.
Then press the yweights onto the guide. To
do this, rst push on two yweights half-way,
then put on the third yweight by setting it on
its edge.
Press the yweights all the way onto the
guide.
CAUTION: Note the position of the springs.
Do not replace springs individually! If
a spring breaks or is fatigued, all three
springs must be replaced. The springs
must not touch the cover.
The illustration shows the inside of the clutch.
Repair Manual EA6100P / EA6101P
Press the disc onto the clutch. It must be at
and be engaged.
Installing the clutch
Install the clutch with the arrow marking point
up.
Mounting torque: 35
Nm
+/-2.5
CAUTION: Before installing the clutch,
disassemble the starter (chap. 06) in order
to prevent damage to the starting catches.
11