Cisco Aironet CB20A Configuration Manual page 41

Chapter 5 Configuring the Client Adapter
In the Authentication Timeout Value field, enter the amount of time (in seconds) before a LEAP
Step 8
authentication attempt is considered to be failed and an error message appears.
Range: 10 to 300 seconds
Default: 90 seconds
Click OK to exit the LEAP Settings screen.
Step 9
Check the Allow Fast Roaming (CCKM) check box on the Network Security screen if you want to
Step 10
enable fast roaming for your client adapter.
Checking this check box enables the client adapter to use CCKM when associated to an access point
•
that uses CCKM or to associate to access points that are not using CCKM.
• Unchecking this check box prevents the client adapter from using CCKM even with access points
that use it.
Default: Unchecked
Note
Step 11 Check the Allow Association to both WPA and non-WPA authenticators check box if you want to
allow the client adapter to associate to access points that are configured for LEAP authentication with:
• WPA enabled (associates with WPA security)
• WPA disabled or not supported (associates without WPA security)
• Cisco migration mode, where WPA is optional (associates without WPA security)
If this check box is not checked, the client adapter can associate only to access points that are configured
for LEAP authentication with WPA.
Default: Unchecked
Note
Click OK to exit the Network Security screen and return to the Profile Manager screen. On the Profile
Step 12
Manager screen, click OK or Apply to save your changes.
Follow these steps if the Microsoft 802.1X supplicant is installed on your computer and you want to take
Step 13
advantage of the fast roaming feature:
a. Perform one of the following steps, depending on your computer's operating system:
–
–
–
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-08
Refer to the "Fast Roaming (CCKM)" section on page 5-28
This parameter is available only if you enable WPA.
If your computer is running Windows 98, 98 SE, NT, or Me, run the Microsoft 802.1X
Authentication Client application. Then go to
If your computer is running Windows 2000, double-click My Computer, Control Panel, and
Network and Dial-up Connections. Right-click Local Area Connection. Click Properties.
The Local Area Connection Properties screen appears.
If your computer is running Windows XP, double-click My Computer, Control Panel, and
Network Connections. Right-click Wireless Network Connection. Click Properties. The
Wireless Network Connection Properties screen appears. Choose the Wireless Networks tab.
Uncheck the Use Windows to configure my wireless network settings check box unless you
are using Windows XP Service Pack 1.
Setting Network Security Parameters
for additional information.
Step c.
5-41