Cisco Aironet CB20A Configuration Manual page 17

Chapter 5 Configuring the Client Adapter
Table 5-4
Parameter
Enable Radio Management
Support
Go to the next section to set additional parameters or click OK to return to the Profile Manager screen.
On the Profile Manager screen, click OK or Apply to save your changes.
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-08
Advanced (Infrastructure) Parameters (continued)
Description
Checking this check box enables the access point to which the client
adapter is associated to control the use of radio management (RM),
provided RM is enabled on the access point. RM is a system-wide
feature that involves multiple infrastructure nodes. The RM feature on
the access point acts on radio measurement requests from other
network devices to instruct the access point and its associated clients
to perform required radio measurements and then report them.
Default: Checked
Note
Note
Setting Advanced Infrastructure Parameters
This parameter is available in Install Wizard version 1.2 or
later for 350 series cards and Install Wizard version 1.3 or
later for CB20A cards.
Access points must use Cisco IOS Release 12.2(13)JA or later
to enable RM. Refer to the documentation for your access
point for instructions on enabling this feature.
5-17