Cisco CiscoWorks 1105 User Manual page 88

Using the Templates
Table 3-7
Field
Enhanced MIC
verify WEP
Temp Key
Integrity Protocol
WEP Key Rotation
Interval
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
3-34
Adding a New VLAN Settings (continued)
Description
From the list, select one of the following:
None—Use this setting if you do not want Message
•
Integrity Check (MIC) enabled.
MMH—Use this setting if you want MIC enabled to
•
protect WEP keys.
When you enable MIC, only MIC-capable client
Note
devices can communicate with the access point.
From the list, select one of the following:
• None—Use this setting if you do not want to enable
the temporal key integrity protocol (TKIP, or WEP
key hashing.)
Cisco—Use this setting to enable TKIP.
•
Note When TKIP is enabled, all WEP-enabled client
devices associated to the access point must
support WEP key hashing, or they will not be
able to communicate with the access point.
Use this setting to enable or disable broadcast key
rotation.
• To enable it, enter the rotation interval in seconds.
If you enter 900, for example, the access point sends
a new broadcast WEP key to all associated client
devices every 15 minutes.
Note When you enable broadcast key rotation, only
wireless client devices using LEAP or EAP-TLS
authentication can use the access point. Client
devices using static WEP (with open, shared key,
or EAP-MD5) cannot use the access point when
you enable broadcast key rotation.
• To disable it, enter 0 (zero).
Chapter 3 Configuring Devices
78-14947-01