Chapter 3
Configuring Devices
Table 3-15 Ethernet Advanced Settings (continued)
Field
Maximum Multicast
Packets/Second
Default Unicast
Address Filter
Always Unblock
Ethernet when STP
is disabled
Optimize Ethernet
for
78-14947-01
Description
Use this setting to control the number of multicast
packets that can pass through the Ethernet port each
second.
If you enter 0, the access point passes an unlimited
number of multicast packets.
If you enter a number other than 0, the device passes only
that number of multicast packets per second.
From the list, select one of the following:
•
allowed—The access point forwards all traffic
except packets sent to MAC addresses that have been
set as disallowed under Association > Address
Filters.
disallowed—The access point discards all traffic
•
except packets sent to the MAC addresses that have
been set as allowed under Association > Address
Filters.
From the list, select one of the following:
From the list, select one of the following:
Yes—Use this setting to maintain a bridge link when
•
STP is disabled
•
No—Use this setting to not maintain a bridge link
when STP is disabled.
Click see details to see which versions this setting is
valid for.
From the list, select one of the following:
Performance—Allows faster packet forwarding.
•
Statistics Collection—Allows better statistics
•
collection.
Click see details to see which versions this setting is
valid for.
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
Using the Templates
3-55