Functional Description; Parts Description - Makita KT001G Instruction Manual

17. Unless the appliance supports the use near
high-voltage electrical power lines, do not use
the battery cartridge near high-voltage electri-
cal power lines. It may result in a malfunction or
breakdown of the appliance or battery cartridge.
18. Keep the battery away from children.
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will also
void the Makita warranty for the Makita appliance and
charger.
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely
discharged. Always stop appliance operation
and charge the battery cartridge when you
notice less appliance power.
2. Never recharge a fully charged battery car-
tridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4. When not using the battery cartridge, remove
it from the appliance or the charger.
5. Charge the battery cartridge if you do not use
it for a long period (more than six months).

PARTS DESCRIPTION

Kettle
► Fig.1
1 Spout
3 Discharge lock button
5 Handle
7 Water volume scale
9 Temperature sensor
Power supply stand
► Fig.2
10 Carrying handle
12 Power switch
14 Temperature sensor
2 Lid
4 Open-lid button
6 Maximum line
8 Power supply connec-
tor (bottom side)
- -
11 Power supply
connector
13 Battery cartridge
15 Ground sensing
element

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the appliance
is switched off and the battery cartridge is removed
before adjusting or checking function on the appliance.
Installing or removing battery cartridge
CAUTION:
Always switch off the appliance
before installing or removing of the battery cartridge.
CAUTION:
Hold the appliance and the battery car-
tridge firmly when installing or removing battery cartridge.
Failure to hold the appliance and the battery cartridge firmly
may cause them to slip off your hands and result in damage to
the appliance and battery cartridge and a personal injury.
To remove the battery cartridge, slide it from the appli-
ance while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
► Fig.3: 1. Red indicator 2. Button 3. Battery cartridge
CAUTION:
Always install the battery cartridge fully
until the red indicator cannot be seen. If not, it may accidentally
fall out of the tool, causing injury to you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
NOTE: Up to two battery cartridges can be installed, although
the appliance uses one battery cartridge for operation.
Indicating the remaining battery capacity
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
► Fig.4: 1. Indicator lamps 2. Check button
Indicator lamps
Lighted
8 ENGLISH
Off Blinking
malfunctioned.
Remaining
capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have