Makita DLM530 Instruction Manual
Cordless lawn mower
Hide thumbs
Also See for DLM530:
- Instruction manual (143 pages) ,
- Instruction manual (141 pages) ,
- Instruction manual (113 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Makita DLM530
Summary of Contents for Makita DLM530
- Page 1 INSTRUCTION MANUAL Cordless Lawn Mower DLM462 DLM530 DLM532 Read before use.
-
Page 2: Specifications
SPECIFICATIONS Model: DLM462 DLM530 DLM532 Mowing width (blade diameter) 460 mm 534 mm No load speed 2,500 min 2,300 min Maximum speed 3,300 min 2,800 min Part number of replacement Straight mower blade 191D51-9 191D52-7 mower blade Swing back mower blades *1... -
Page 3: Safety Warnings
) : 90.9 dB (A) cycle such as the times when the tool is switched Uncertainty (K) : 3 dB(A) off and when it is running idle in addition to the Model DLM530 trigger time). Sound pressure level (L ) : 78.1 dB(A) Sound power level (L ) : 90.4 dB (A) - Page 4 Be sure the area is clear of other people before - whenever the mower starts vibrating mowing. Stop mower if anyone enters the area. abnormally. Do not insert the lock key into mower until it is Never operate the mower with defective ready to be used.
- Page 5 Check the grass basket frequently for wear or 23. If the mower strikes a foreign object, follow these steps: deterioration. For storage, always make sure - Stop the mower, release the switch lever and the grass basket is empty. Replace a worn wait until the blade comes to a complete stop.
- Page 6 Important safety instructions for have been altered, may result in the battery bursting battery cartridge causing fires, personal injury and damage. It will also void the Makita warranty for the Makita tool and Before using battery cartridge, read all instruc- charger. tions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery.
-
Page 7: Installing The Handle
Firmly tighten 4 bolts which were temporarily Tips for maintaining maximum tightened in step 1 using box wrench 13. battery life Align the hole in the lower handle with the hole in Charge the battery cartridge before completely dis- the upper handle, then insert the bolt from inside, and charged. -
Page 8: Removing The Mulching Plug
Hold the handle of the grass basket, and then Removing the mulching plug hook the grass basket on the rod of the mower body as shown in the figure. Open the rear cover. ► 1 . Rear cover ► 1 . Rod 2. Handle 3. Grass basket Remove the mulching plug while holding down the To remove the grass basket, open the rear cover, and lever. -
Page 9: Functional Description
Attaching the discharge attachment FUNCTIONAL DESCRIPTION For DLM530/DLM532 Open the rear cover, and then remove the grass basket. Installing or removing battery cartridge Always switch off the machine CAUTION: before installing or removing of the battery cartridge. CAUTION: Hold the machine and the battery cartridge firmly when installing or removing bat- tery cartridge. - Page 10 Align the tongue on the battery cartridge with the Switching the battery cartridges slot on the machine, and then slide the cartridge until it locks in place with a little click. ► 1 . Battery selection switch ► ( 1) Battery port 1 (2) Battery port 2 (3) Battery The machine uses 2 battery cartridges for operation cartridge at a time.
-
Page 11: Control Panel
Indicating the remaining battery Control panel capacity The control panel has the main power switch, the mode switching button, and the indicator of remaining battery Only for battery cartridges with the indicator capacity. ► 1 . Indicator lamps 2. Check button Press the check button on the battery cartridge to indi- cate the remaining battery capacity. - Page 12 If you notice anything unusual with either of the Select the battery cartridges used for operation by lock key or switch, stop the operation immediately and turning the battery selection switch. have them checked by your nearest Makita Authorized Press the main power switch. Service Center. For DLM462/DLM532 Install the battery cartridges.
-
Page 13: Adjusting The Mowing Height
Pull the switch lever toward you while holding Number Mowing height down the switch button. Release the switch button as 20 mm soon as the motor starts running. 26 mm 32 mm 39 mm 47 mm 55 mm 63 mm 74 mm 86 mm 100 mm... -
Page 14: Adjusting The Handle Height
► ( 1) 30 mm or more (2) 15 mm or less Using discharge attachment For DLM530/DLM532 The discharge attachment allows you to discharge the cut grass to the ground from the right side of the machine without gathering the cut grass in the grass basket. -
Page 15: Electronic Function
The center lines of the front wheels are guidelines to the mower blades after releasing the switch lever, mowing width. Using the center lines as guidelines, have the machine serviced at Makita Authorized mow in strips. Overlap by one half to one third the previ- Service Center. -
Page 16: Maintenance
To maintain product SAFETY and RELIABILITY, once may cause the grass to die. The cut grass may repairs, any other maintenance or adjustment should also block up inside of the mower body. be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. Emptying the grass basket Maintenance... -
Page 17: Carrying The Mower
Removing the mower blade Carrying the mower For models equipped with straight mower When carrying the mower, hold the front grip and rear grip with two people as shown in the figure. blade Put the mower on its side so that the mowing height adjusting lever comes to the upper side. To lock the blade, insert the pin into a hole on the mower body. - Page 18 For models equipped with swing back To remove the individual mower blade, turn the bolt counterclockwise with box wrench 17 while holding mower blades the base plate. Put the mower on its side so that the mowing height adjusting lever comes to the upper side. To lock the base plate, insert the pin into a hole on the mower body through a hole on the base plate.
-
Page 19: Troubleshooting
To install the mower blades, perform the removal proce- dure in reverse. TROUBLESHOOTING Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, do not attempt to disassemble the machine. Instead, ask Makita Authorized Service Centers, always using Makita replacement parts for repairs. State of abnormality Probable cause (malfunction) Remedy Mower does not start. - Page 20 Jan-Baptist Vinkstraat 2, Makita Europe N.V. 3070 Kortenberg, Belgium 3-11-8, Sumiyoshi-cho, Makita Corporation Anjo, Aichi 446-8502 Japan 885760-229 www.makita.com 20191017...