Makita VC2211M Instruction Manual page 6

1. Storing the power supply cord
013461
NOTICE:
Do not use the cleaner or a connected electric
•
power tool with a power supply cord wound on
the base hook. Using the cleaner or the
connected electric power tool with power supply
cord may cause damage the power supply cord.
2. Storing the front cuffs
013373
Front cuffs 22, 24 and 38 can be stored (up to two at a
time).
3. Storing the hose
013480
4. Resting a reasonable size of electric power
tool for the base hook, such as circular saw
013481
1. Base hook
2. Power supply
cord
1
2
1. Front cuffs
1
1. Hose
1
Locking or unlocking the caster
3
1
4
2
013482
To lock the caster with a stopper, lower the stopper lever
and the caster no longer will rotate. To release the
caster from the locked position, raise the stopper lever.
Locking the caster is convenient when storing the
cleaner, stopping the work on the way and keeping the
cleaner still.
To operate the stopper, move it by hand.
NOTICE:
When moving the cleaner, make sure that the
•
caster is unlocked. Moving the cleaner with the
caster in the locked position may cause damage to
the caster.
Cap
There is a cap on the mounting port. The cap prevents
the vacuumed dust from getting out from the cleaner.
ASSEMBLY
WARNING:
This unit may contain hazardous dust. When
•
replacing filter elements and dust bag, always use
a P2-respirator.
Always be sure that the cleaner is switched off and
•
unplugged before carrying out any work on the
cleaner.
Never switch on until all filters and dust bag are
•
completely installed and the volume flow control is
tested.
Installing and disposing the filter bag
WARNING:
Always use a P2-respirator.
•
When using the filter bag, also use the air filter
•
together that is preinstalled on the tool. Failure to
use the air filter together may cause unusual noise
and heat, resulting in a fire.
CAUTION:
Never pick up water or other liquids or wet dusts
•
when using the filter bag. Picking up such things
may cause the filter bag breakage.
6
1. FREE position
2. LOCK position
3. Stopper lever
4. Caster