Makita DHR182RTJ Instruction Manual page 13

3. Install the dust cup set so that the claws of the
dust cup fit in in the slits on the spacer.
1
2
► 1 . Dust cup 2. Claws
NOTE: If you connect a vacuum cleaner to the dust
cup set, remove the dust cap before connecting it.
1
► 1 . Dust cap
Removing the drill bit
To remove the drill bit, pull the chuck cover down all the
way and pull the drill bit out.
► 1 . Bit 2. Chuck cover
Removing the dust cup set
To remove the dust cup set, follow the steps below.
1. Loosen the side grip.
► 1 . Side grip
2. Hold the root of dust cup and pull it out.
► 1 . Dust cup
NOTE: If it is difficult to remove the dust cup set,
remove the claws of the dust cup one by one by
swinging and pulling the root of the dust cup.
1
NOTE: If the cap comes off from the dust cup, attach
it with its printed side facing up so that groove on the
cap fits in the inside periphery of the attachment.
2
13 ENGLISH
1
1