The Radio; Manual Tuning; Preset Tuning - Panasonic SC-HT800V Operating Instructions Manual

The radio

Í
PLAY MODE
OPEN/CLOSE/EJECT
3CH W
4CH X
ENTER
VOLUME
s r
Preparation
≥Press [TUNER] to put the remote control in TUNER mode.
≥Press [Í] to turn on the unit.
≥Press [FM/AM] to select "FM" or "AM" as the source.

Manual tuning

1
Press [6] or [5] to select the
frequency of the required station.
TUNED: Displayed when a radio station is
tuned.
ST: Displayed when a stereo FM
broadcast is being received.
Press and hold [6] or [5] until the frequency starts
scrolling to start automatic tuning. Tuning stops when a
station is found.
2
Adjust the volume.
∫ If noise is excessive in FM
Press [PLAY MODE] to display "MONO".
Press [PLAY MODE] again to cancel the mode.
The mode is also canceled when you change the
frequency.
∫ FM frequency step
The step is factory-set to 0.2 MHz, but you can change it to receive
broadcasts allocated 0.1-MHz steps.
1 Press [FM/AM] to select "AM".
2 Press and hold [FM/AM].
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The
minimum frequency changes and the step is changed.
To return to the original step, repeat the above steps.
RQT6951 [Note]
46
Any FM and AM frequencies preset in channels will be initialized by
this procedure. Preset them again.
DVD/VCR FM/AM REC
FM/AM
DVD TV TUNER
VCR
TUNER
RESET
TV/VIDEO
1 2 3
PAGE
GROUP
4 5 6
PICTURE MODE/
SETUP Numbered
7 8 9
buttons
REPEAT
PLAY MODE S10/ENTER
100 0
SKIP SLOW/SEARCH
6 5
TV VOLj TV VOLi JET REW
TOP MENU MENU
CH
NAVI
DIRECT PLAY LIST
NAVIGATOR
ENTER
OSD/DISPLAY RETURN
CH
VOLUME
D.RE-MASTER C.S.M C.FOCUS S.POSITION
MUTING
SUBWOOFER SFC SUPER SRND
POSITION
MEMORY SUBTITLE ZOOM QUICK REPLAY
PROG CANCEL SPEED
SLEEP AUDIO TEST
[SHIFT]
ÎPL MIX 2CH CH SELECT

Preset tuning

Preset channels to make selection simple.
Up to 15 stations can each be set in the FM and AM bands.
Automatic presetting
1
Tune to "FM 87.9" MHz or "FM
87.5" MHz (➡ left).
2
Press and hold [ENTER].
Release the button when "AUTO" is displayed.
The tuner presets all the stations it can receive into the
channels in ascending order.
"SET OK" is displayed when the stations are set. The last
station to be set is then played.
3
Tune to "AM 520" kHz.
4
Press and hold [ENTER].
"ERROR" is displayed
Presetting was unsuccessful. Preset manually.
Manual presetting
1
Tune to the station (➡ left).
2
Press [ENTER].
3
While "PGM" is flashing
Press the numbered buttons to select
a channel.
Alternatively, press [3 CHW]
or [4 CHX] then press
[ENTER].
The station occupying a channel is
erased if another station is preset in that channel.
Selecting channels
TUNEDST
1
Press [FM/AM] to select "FM" or
"AM".
2
Press the numbered buttons or
[3 CHW] or [4 CHX] to select the
channel.
MONO
To select a 2-digit number
Example: To select channel 12, press [S10] ➡ [1] ➡ [2]
[Note]
The unit of display is MHz for FM radio and kHz for AM radio when
the selector is in TUNER mode.
PGM