Plug-In Auto Tuning - Panasonic SC-HT800V Operating Instructions Manual

5
STEP

Plug-in Auto Tuning

DVD/VCR FM/AM
Í
DVD TV
VCR
RESET
TV/VIDEO
1 2
PAGE
GROUP
4 5
PICTURE MODE/
SETUP
7 8
REPEAT
PLAY MODE
100 0
SKIP SLOW/SEARCH
TV VOLj TV VOLi JET REW
OPEN/CLOSE/EJECT
TOP MENU
CH
NAVI
DIRECT
NAVIGATOR
ENTER
OSD/DISPLAY
CH
VOLUME
D.RE-MASTER C.S.M C.FOCUS
SUBWOOFER SFC SUPER SRND
POSITION
MEMORY SUBTITLE ZOOM QUICK REPLAY
PROG CANCEL SPEED
SLEEP AUDIO
[SHIFT]
ÎPL MIX 2CH
POWERÍ/I
POWER Í /I
VCR EJECT
REC TIMER REC /REW FF/
STOP PLAY
REC
DVD/VCR
TUNER
VCR
3
6
9
S10/ENTER
MENU
MENU
PLAY LIST
RETURN
S.POSITION
MUTING
TEST
CH SELECT
CH X CH W
OPEN/CLOSE
DVD
CH CH PROGRESSIVE SELECTOR VOLUME
STOP PLAY
DOWN UP PHONES
After plugging the unit into your household AC outlet and pressing
[Í] to turn the unit on for the first time, the unit automatically tunes
in all the channels it can receive and sets the clock.
The unit determines the type of transmission, TV or CATV, as
follows:
TV: when there are less than 5 CATV channels.
CATV: when there are 5 or more CATV channels.
Preparation
≥Confirm that the antenna is connected correctly.
≥Turn on the television and select the video input for the VCR.
≥Press [VCR] to put the remote control in VCR mode.
Press [Í] to turn on the unit.
Plug-in Auto Tuning starts and the unit puts the stations it can
receive into channels (➡ page 43, Channel range).
AUTO CHANNEL SET
PROCEEDING
END
The unit starts auto clock setting when finished, then displays the
time.
[Note]
If auto tuning stops partway (by changing the source, turning the
unit off, or due to a power failure.)
1 Disconnect the AC power supply cord on the main unit and then
reconnect it.
2 Turn on the main unit.
To cancel partway
Press [MENU].
∫ To start Plug-in Auto Tuning again (after
relocation, for example)
Preparation
≥Press [Í] to turn on the unit.
≥Make sure there is no video cassette tape loaded in the unit.
≥Press [DVD/VCR] to select "VCR" as the source.
1 Press and hold [CHX] and [CHW] on the main unit
simultaneously for 3 seconds until the channel changes to "2".
Disappears
2 Disconnect the AC power supply cord on the main unit and then
reconnect it.
3 Turn on the main unit. Plug-in Auto Tuning restarts.
Antenna system and channel captions all revert to the
default values when you perform the procedure above.
Reset the timer recording settings. (If necessary reset the
clock first. ➡ page 42, CLOCK SET)
∫ To set the channels manually (➡ page 43).
∫ If the unit couldn't set the clock automatically
The MANUAL CLOCK SET screen appears. Set the time manually
(➡ page 42).
2
:MENU
2
RQT6951
15