Huawei TE80 Administrator's Manual page 152

HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
Parameter
Trap server
address 1
Trap server
address 2
Trap server
address 3
Trap version
Trap timeout
time
Trap retry
times
User name
Authenticati
on protocol
Authenticati
on password
Encryption
protocol
Encryption
password
Issue 02 (2014-03-30)
Description
Specify the IP address to which your
endpoint sends traps, namely, the IP
address of the computer where the
videoconferencing network management
system server is installed.
NOTE
A trap is an unrequested message that a
managed device (for example, an endpoint)
sends to a trap server (for example, the SMC)
to report urgent and important events.
Version of the traps that the endpoint
sends to the videoconferencing network
management system through SNMP.
Specifies the timeout interval for traps,
in seconds.
This parameter is available only when
Trap version is set to v2 inform or v3
inform.
Specifies the number of retry attempts
for sending a trap.
This parameter is available only when
Trap version is set to v2 inform or v3
inform.
Specifies the user name for sending
traps.
This parameter is available only when
Trap version is set to v3 trap or v3
inform.
Specify the authentication mode and
password that your endpoint uses to send
traps to the videoconferencing network
management system through SNMP.
This parameter is available only when
Trap version is set to v3 trap or v3
inform.
Specify the encryption protocol and
password that your endpoint uses to send
traps to the videoconferencing network
management system through SNMP.
If you select No encryption for
Encryption protocol, traps are
transmitted using plaintext.
This parameter is available only when
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 Feature Configuration
Setting
characters.
No default value is set for this
parameter.
You can leave this parameter
blank.
The default value is v3 trap.
The default value is 1.
The default value is 5.
The default value is trapinit.
The default value of
Authentication protocol is
MD5.
Set Authentication password
to the password defined on the
videoconferencing network
management system.
If the two passwords are not the
same, authentication fails.
The default value of
Encryption protocol is DES.
Set Encryption password to a
string of 1 to 32 characters,
which contains letters, digits,
and special characters.
144