Table of Contents
Advertisement
10.5.6
Menu
CALIBRATE
Item
page 64
008-0671-00
This menu item performs a calibration according to what was entered in the
and
TION TYPE
CALIBRATION DATA
NOTICE
Before performing a calibration, the transducer must be connected to the
instrument, the
CALIBRATION TYPE
Menu Item" on page 60), and the
BRATION DATA Sub-Menu" on page 62).
NOTICE
For maximum accuracy, allow at least twenty minutes of warm-up with the exci-
tation voltage applied to the transducer before calibration.
If the
is Shunt Calibration...
CALIBRATION TYPE
•
The display will read
DOING SHUNT CAL
00000 and UNIT are previously entered as
When you have applied this load to the transducer, press [ENTER].
•
The display will then read
tion, the display will indicate
If the
is mV/V Calibration...
CALIBRATION TYPE
•
The display will read
DOING MV/V CAL
00000 and UNIT are previously entered as
When you have applied this load to the transducer, press [ENTER].
•
The display will then read
tion, the display will indicate
If the
is 2-Point Known Load Calibration...
CALIBRATION TYPE
•
The display will read
DOING 2POINT CAL
00000 and UNIT are previously entered as
When you have applied this load to the transducer, press [ENTER].
•
The display will read
WORKING
viously entered as
KNOWN POINT 2/2
load to the transducer, press [ENTER].
•
Upon completion, the display will indicate
RUN mode.
If the
is 3-Point Known Load Calibration...
CALIBRATION TYPE
•
The display will read
DOING 3POINT CAL
00000 and UNIT are previously entered as
When you have applied this load to the transducer, press [ENTER].
•
The display will read
WORKING
viously entered as
KNOWN POINT 2/3
load to the transducer, press [ENTER].
•
The display will read
WORKING
viously entered as
KNOWN POINT 3/3
load to the transducer, press [ENTER].
•
Upon completion, the display will indicate
menu items.
must be selected (see "CALIBRATION TYPE
must be entered (see "CALI-
CALIBRATION DATA
, and prompt you to
ZERO SCALE VALUE
and calibration will take place. Upon comple-
WORKING
and the instrument will return to the RUN mode.
DONE
, and prompt you to
ZERO SCALE VALUE
and calibration will take place. Upon comple-
WORKING
and the instrument will return to the RUN mode.
DONE
, and prompt you to
KNOWN POINT 1/2
, then
(where 01000 and UNIT are pre-
APPLY 01000 UNIT
and
). When you have applied this
DISPLAY. UNITS
and the instrument will return to the
DONE
, and prompt you to
KNOWN POINT 1/3
, then
(where 00500 and UNIT are pre-
APPLY 00500 UNIT
and
). When you have applied this
DISPLAY. UNITS
, then
(where 01000 and UNIT are pre-
APPLY 01000 UNIT
and
). When you have applied this
DISPLAY. UNITS
and the instrument will return to the
DONE
CALIBRA-
(where
APPLY 00000 UNIT
and
.
DISPLAY. UNITS
(where
APPLY 00000 UNIT
and
).
DISPLAY. UNITS
(where
APPLY 00000 UNIT
and
).
DISPLAY. UNITS
(where
APPLY 00000 UNIT
and
).
DISPLAY. UNITS
Advertisement
Table of Contents
Troubleshooting
