Writing Product Setting Information To The Product (Setting Change) (Common Settings, Enable F/R Lever Setting) - Makita TD Series User Manual

3-7. Writing Product Setting Information to the Product (Setting Change)
(Common Settings, Enable F/R lever Setting)
The product operation settings that can be changed are as follows.
Important! To transfer the settings to the product, click "Write" button of "Access to Tool" after clicking
the buttons or entering the values to set the corresponding items. The product settings will
not change until you click the button.
Important! When you click "Write" of "Access to Tool", do not remove the USB cable until the
message of Settings Change Finish is displayed. Not only the settings will not be
reflected, but also the tool may not work properly.
If this happens, connect the tool with a USB cable and complete writing the settings
again.
Setting item: Common Settings
1. Initialize
To initialize the settings of "Common Settings" to the factory default condition, click "Initialize".
(The product settings are not changed at this time.)
2. Lighting
The product LED indicator lighting can be set.
(When "Bright" or "Dim" is selected, the afterglow function operates interlocked with trigger operation.)
 "Bright"
 "Dim"
 "OFF"
3. Buzzer
The buzzer sound can be set to "ON" or "OFF."
 "ON"
 "OFF"
4. Trigger Variable Speed
Trigger Variable Speed can be set to "ON" or "OFF."
 "ON"
 "OFF"
32
Important! You must click "Write" under "Access to Tool" to change
the product settings.