Password Setting When Writing The Product Settings - Makita TD Series User Manual

3-5. Password setting when writing the product settings

You can set a requirement for a password when writing settings for the product by turning the password
setting ON. You can enter up to 8 one-byte alphanumeric characters.
When the password setting is ON and you click the "Write" button on the "Access to Tool", you will be
required to enter the password before transferring the settings to the product.
You can also change your password by clicking "Change Password".
Enter the old password and the new password, and click the "OK" button.
Important! The password is required only when the application is launched and the first product settings are
written. If you click the Close button in the upper right corner of the window without entering a
password, the configuration information will not be transferred to the product.
Important! You need to enter the password to change the password setting ON/OFF.
Note! The default password after the application is installed is "0000". When you forget the password, you
have to uninstall the application first, and then re-install the application by referring to the attached
"Install manual.pdf" file.
30