Introduction Of Display; Cleaning And Maintenance; Mains Plug Replacement - Black & Decker HM6000-B5 Manual

ENGLISH

Introduction of display

Function icon Function
Digital display
TIMER Timer function
UV UV
AUTO Auto mode
Power on/off Power on and off
Sleep mode
SLEEP
function
NO WATER Water shortage indicator
Remarks:
1. Once a function is selected, the display will be lit bright.
After 5 seconds, the brightness of the digital display and
the function indicator light will dim.
2. Once the machine is turned off, the atomizer stops
working but the airflow will stop working after a few
seconds to ensure the mist inside the fuselage is
discharged.
3. For users who are sensitive to the noise of the machine,
it is recommended to use sleep mode or place the
machine at least 2-3 meters away.
4. If the humidifier is used in an environment with high
humidity and low air circulation, it is normal to see
condensation on the water tank's cover.

Mains plug replacement

If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal of the new
plug.
• Connect the blue lead to the neutral terminal.
• If the product is class l (earthed), connect the green /
yellow lead to the earth terminal.
Warning! If your product is class ll double insulated (only 2
wires in the cord set), no connection is to be made to the
earth terminal.
Follow the fitting instructions supplied with good quality
plugs.
Any replacement fuse must be of the same rating as the
original fuse supplied with the product.
6
(Original instructions)
1. The digital display number represents the ambient humidity value during normal use.
2. Select the auto mode to choose the humidity level you want for your room. After selection, the display will show the
real-time ambient humidity value after 3 seconds.
3. The timer function lets you choose the hours you want the unit to work for. After you have selected the desired
hours that you want the timer to function, the display will show the ambient humidity value after 3 seconds.
When the timer function is pressed, the timer's time can be set from: 1 hour → 2 hours → 3 hours → ... 12 hours → 00
(turn off timer). After the timer is selected, the display returns to display the ambient humidity value.
Turning on the UV function can effectively reduce the spray of mist bacteria.
When the Auto mode is turned on, the indicator lights up, and the user can adjust the range value that needs constant
humidity. The machine will automatically adjust the appropriate mist amount according to the humidity range value
selected by the user and the current environmental humidity value.
Press the power button to turn on the machine when the power is turned on. The default speed is "speed 1".
Press the power button again to power off.
When the sleep function is turned on, the mist is in a low speed, the digital display is turned off, the other indicators are
dimmed, and the quiet humidification state is entered.
Indicates that the machine is short of water. You would require to add water for the indicator to turn off and
the unit will start running again.
Explanation

Cleaning and maintenance

1. Before cleaning, be sure to turn off the power supply and
unplug the power plug.
2. If there is scale on the inner wall of the tank, remove the
tank from the equipment, open the tank, then wipe it with
a towel or brush, and rinse it with clean water. Then pour
out the water (as shown below).
Be careful:
1. After pouring water into the water tank, it should be noted
that there will be a small amount of water in the
mist tube. The water can be poured out from the mist
tube hole at the bottom of the water tank.
2. Please rotate to open the tank and then clean the tank.
Warning! Do not immerse the whole tank in water for
cleaning, in order to prevent short circuit and other
dangers after water entry.