Installation - Black & Decker HM6000-B5 Manual

Features
1. Mist output
2. Water tank assembly
3. Display
4. Indicators
5. On/Off
6. Float
7. Atomizer
8. Aroma box
9. Remote
a. Power ON/OFF
b. Reduce speed
c. Increase speed
d. AUTO
e. Sleep mode
f. Timer
g. UV

Installation

1. Water tank
Note: Assemble the Water tank assembly, Atomizer and the
float as shown in Fig 1. Assemble the lower cover of the
water tank in place and then rotate it in the direction of the
arrow to complete the assembly (Fig. 1).
2. Sponge and aroma box
Add aroma: (Select aroma according to your needs) Add
aroma to the aroma tray (This product does not come with
essential oils). It is advised to use plant based essential oils.
Fig. 1
Sponge
Aroma box
(Original instructions)
Use
1. Place the machine vertically in a suitable location.
2. After removing up the transparent
decorative cover of the water tank,
use a container filled with water
(such as a water cup) to fill a certain
amount of water to the water tank.
Note:
1. Please add water into the water
tank, do not pour water into the fog
tube.
2. In the water tank, pour clean water
between 6°C - 40°C. Do not add
water to the water tank beyond the
MAX level.
3. Connect the power supply, buzzer
sounds, indicating that the power is
turned on; press button at this time
to start the machine, you can select
the mode and function according to your needs with the
help of remote control.
4. When there is a water shortage, the machine will
automatically stop the fog, the red light will blink and the
fan will delay by 15 seconds and the unit will shut down. If
you need to continue using it, disconnect the power and
refill the water tank.
5. Before moving the humidifier, please turn off the power
and unplug the power plug, and move the whole machine
together. Do not move the humidifier under working
conditions.
6. To remove the remaining water from the water tank for
cleaning purposes, first turn off the power and unplug the
power supply. Then lift the water tank and then pour out
the remaining water.
Introduction of remote control
a. Power button: Press the power button to turn on the
machine when the power is turned on. The default speed
is "speed 1". Press the power button again to power off.
b. "-": Reduce the amount of mist.
c. "+": Increase the amount of mist.
d. Auto: The machine is set to the intelligent Auto mode.
e. Sleep button: The machine is set to sleep mode.
f. Timer: The machine is set to the timer mode.
g. UV: Activates the sterilization function when pressed. To
turn it off, press the button again.
Tips: Use the remote control while facing the humidifier
panel from a distance of less than 5m.
ENGLISH
5