Makita RT0702C Instruction Manual page 11

Using the tilt base protector with the
base
The tilt base protector (square) removed from the tilt
base can be mounted on the base. The shape of the
base protector can be changed from round to square.
1.
Remove the tilt base protector from the tilt base by
loosening and removing the four screws.
2. Mount the tilt base protector on the base.
2
Fig.27
► 1. Tilt base protector 2. Screw
Offset base
Optional accessory
The offset base is used for trimming the edge of lami-
nate sheet or similar materials.
The offset base is convenient for work in a tight area.
Fig.28
Using the tool with the offset base
1.
remove the collet nut and collet cone by loosening the
collet nut.
1
Fig.29
► 1. Pulley 2. Collet nut 3. Collet cone
2.
lock and firmly tightening the pulley with a wrench.
Fig.30
► 1. Wrench 2. Pulley 3. Shaft lock
3.
the offset base as shown in the figure.
Fig.31
► 1. Collet nut 2. Collet cone
11 ENGLISH
Before installing the tool on the offset base,
3
2
Install the pulley on the tool by pressing the shaft
1
2
Place the collet cone and screw the collet nut on
1
3
2
1