Makita RT0702C Instruction Manual page 10

2. Drive a nail less than 6 mm in diameter into the
center hole to secure the straight guide.
3.
Pivot the tool around the nail in clockwise
direction.
Trimmer guide
Optional accessory
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
Fig.23
1. Install the trimmer guide and guide holder on the
base with the clamping screw (A).
2. Loosen the clamping screw (B) and adjust the
distance between the trimmer bit and the trimmer guide
by turning the adjusting screw (1 mm per turn). At the
desired distance, tighten the clamping screw (B) to
secure the trimmer guide in place.
A
1
B
3
Fig.24
► 1. Adjusting screw 2. Guide holder 3. Trimmer guide
3. When cutting, move the tool with the guide roller
riding the side of the workpiece.
Fig.25
► 1. Workpiece 2. Trimmer bit 3. Guide roller
Tilt base
Optional accessory
The tilt base is used for trimming the edge of laminate
sheet or similar materials.
The tilt base is convenient for chamfering.
1. Place the tool onto the tilt base, loosen the clamp-
ing screws, and tilt the tool at the desired angle.
2. Close the locking lever at the desired protrusion of
the trimmer bit, and tighten the clamping screws at the
desired angle.
3. Firmly clamp a straight board to the workpiece and
use it as a guide against the tilt base. Feed the tool in
the direction of the arrow.
Fig.26
► 1. Clamping screws 2. Locking lever
2
10 ENGLISH
1
2
2
3
1