Honeywell ADEMCO LYNX XL Series Installation And Setup Manual page 52

Table of Contents

Advertisement

LXL-1010 Installation and Setup Guide
Z N 0 1 B A C K
Z N 0 1 B A C K
Z N 0 1 B A C K
D O O R
Z N 0 1 B A C K
D O O R
Z N 0 1 B A C K
D O O R
9-2
www.PDF-Zoo.com
First 3-Digit Index No.
see index for entries
[∗] to continue
Accept First Word
6 = save word and go to next
word in this descriptor
8 = save word and end
descriptor- go to next zone
Second 3-Digit Index No.
see index for entries
[∗] to continue
Accept Second Word
6 = save word and go to last
word in this descriptor
8 = save word and end
descriptor- go to next zone
Summary Screen
[∗] to continue
firealarmresources.com
Press [#] plus the 3-digit number for the first word from the Alpha
Vocabulary List. Example: The descriptor that we wish to enter for
zone 1 is BACK DOOR. From the list, BACK = 013. Therefore, you
would enter #013.
Note: If you accidentally enter the wrong word, simply press [#] plus
the correct 3-digit number for the word you want.
Press [6] to accept the selected word and continue to the next word.
NOTE: If this is the only word you are using for the descriptor, press
[8] instead of [6] to save that word in memory.
Enter the 3-digit number for the next word. In our example, the word
is DOOR, whose number is "057."
Enter # 0 5 7.
Press [6] to accept the selected word.
NOTE: If these are the only words you are using for the descriptor,
press [8] instead of [6] to save them in memory.
The two words in our example have now been entered. Note, however,
that up to three words may be entered (provided the number of
characters will fit on the screen).
Press [8] to save all words in memory.
The flashing cursor will disappear, indicating that the word(s) are
stored in memory for that zone, as shown in the summary display at
the left.
To enter a descriptor for the next zone, press [ ✱] plus the desired zone
number (e.g., ✱ 02). The summary display will appear. Now repeat the
previous steps to enter the descriptor for the next zone.
To exit the Alpha descriptor mode, press ✱ + 0 + 0 at the summary
display.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lxl-1010

Table of Contents