Honeywell POSI3 USB Quick Start Manual page 6

12. Installation will require a confirmation then will
proceed without interference
13. When the installation is done, uncheck Launch
Stack Builder at exit. Click Finish.
14. When you are back at the Database Installation
Wizard, click Next to configure the PostgreSQL
Server into the POSI Software.
15. Follow the below default configuration. Click
Logon.
POSI3 USB Quick Start Guide
6
Page
16. When you are back at the Database Installation
Wizard, click Next to install the model's
database.
17. The Database Installation Wizard will use the
configured location, port to use, as well the Server
Owner Name and Password. Click Next.
18. Select Install a NEW test results database and
click "Next".
of 11
P/N 13-395 11/4/20 Rev.05