Makita M3602 Instruction Manual page 8

Straight guide (Type B)
Optional accessory
Insert the straight guide into the holes in the tool base
and tighten the thumb screw. To adjust the distance
between the router bit and the straight guide, loosen the
thumb screw. At the desired distance, tighten the thumb
screw to secure the straight guide in place.
1
2
Fig.11
► 1. Thumb screw 2. Straight guide
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
Wider straight guide of desired dimensions may be
made by using the convenient holes in the guide to bolt
on extra pieces of wood.
When using a large diameter router bit, attach pieces
of wood to the straight guide which have a thickness of
more than 15 mm (5/8") to prevent the router bit from
striking the straight guide.
C
A
2
Fig.12
► 1. Straight guide 2. Wood
A=55 mm (2-3/16")
B=55 mm (2-3/16")
C=15 mm (5/8") or thicker
1
B
Templet guide
Optional accessory
The templet guide provides a sleeve through which the router
bit passes, allowing use of the router with templet patterns.
Fig.13
1. Loosen the screws on the base, insert the templet
guide and then tighten the screws.
Fig.14
► 1. Screws 2. Templet guide
2. Secure the templet to the workpiece. Place the
tool on the templet and move the tool with the templet
guide sliding along the side of the templet.
2
3
4
5
Fig.15
► 1. Router bit 2. Base 3. Base plate 4. Templet
5. Workpiece 6. Templet guide
NOTE: The workpiece will be cut a slightly different size
from the templet. Allow for the distance (X) between the
router bit and the outside of the templet guide. The distance
(X) can be calculated by using the following equation:
Distance (X) = (outside diameter of the templet
guide - router bit diameter) / 2
8 ENGLISH
1
(X)
2
1
6