Maintenance - Makita M3602 Instruction Manual

Spacer (For tool with the knob)
Optional accessory
The spacer prevents the router bit from dropping into
the chuck when replacing the router bit in the inverted
position.
Insert the spacer as illustrated when using the tool with
a router stand available in the market.
1
Fig.20
► 1. Collet nut 2. Collet cone 3. Spacer
Dust extraction
Optional accessory
Use the dust nozzle for dust extraction.
Fig.21
► 1. Dust nozzle
Installing the dust nozzle
1
2
Fig.22
► 1. Support 2. Lock lever
1. Raise the lock lever of the dust nozzle.
2. Place the dust nozzle onto the tool base so that its
top will be caught in the hook on the tool base.
3. Insert the supports on the dust nozzle into the
hooks on the front of the tool base.
4. Push down the lock lever onto the tool base.
5. Connect a vacuum cleaner to the dust nozzle.
2
3
Fig.23
Removing the dust nozzle
1. Raise the lock lever.
2. Pull the dust nozzle out of the tool base while
holding the supports between thumb and finger.

MAINTENANCE

CAUTION:
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
1
Replacing carbon brushes
Fig.24
► 1. Limit mark
Check the carbon brushes regularly.
Replace them when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
10 ENGLISH
Always be sure that the tool is
Never use gasoline, benzine, thinner,
1