Central Operation Functions - Hitachi YUTAMPO Series Service Manual

3 Control functions

Central Operation functions

3.11 Central Operation functions
In case that the YUTAMPO unit is connected to a central operation device (KNX,Modbus, etc.) it is necessary to configure the control
type (local or full) and the H-LINK Address for the refrigerant cycle and the indoor unit.
27 SMGB0135 rev.0 - 06/2020
In case that the YUTAMPO unit is connected a
central operation device (KNX,Modbus, etc.)
• Local: Central orders are disabled
• Full: Central orders are enabled
H-LINK communication addresses must be
assigned in case that the YUTAMPO unit is
connected to a central operation device (Default
values: 0:0)
3