Honeywell HW-AV-LTE-M Product Installation Document page 4

To Wire the Panel with the Communicator
Panel's Terminal
AUX
GND
Primary Dialer
Backup Dialer
CAUTION
DO NOT USE RESETTABLE POWER TERMINALS.
Powering ON
01. Power ON the communicator and the panel.
02. Ensure that the panel and the communicator are receiving power.
03. Ensure that the Green LED on the communicator is continuously ON indicating successful connections.
NOTE: Refer to the Troubleshooting section if there is an issue to resolve.
Panel's
Connections at CLSS Pathway
Connector
+
Connect to +
- Connect to -
RING Connect to RING
TIP Connect to TIP
RING2 Connect to RING2
TIP2 Connect to TIP2
Figure 2: Wiring for Dialer Capture
4