Makita UH5580 Instruction Manual page 10

Remove the under cover.
1
► 1 . Under cover 2. Blade cover
Remove the gear housing cover.
1
► 1 . Gear housing cover
Set the crank at the angle as shown in the figure with a
slotted bit screwdriver.
1
► 1 . Crank
Remove two screws from the shear blades and the
shear blade unit will be taken out.
2
2
► 1 . Screws 2. Shear blade
CAUTION:
• Return the gear to the original position in such
a manner as it was installed if it should be taken
away by mistake.
Installing the shear blade
Prepare 4 removed screws (For under cover), 2 screws (For shear
blade), gear housing cover, under cover, and new shear blades.
Adjust the crank position as shown in the figure. At
this time, apply some grease provided with new shear
blades to the periphery of the crank.
► 1 . Crank
Overlap the oval hole in the upper blade with that in the
lower one.
1
► 1 . Ellipse of shear blade
10 ENGLISH
1
1