Configuration; Wizard Settings - Tripp Lite NGI-S16 Owner's Manual

4. Configuration

Initially, the new device connects the network using default IP (192.168.0.254). Access the IP
address to enter the Wizard. After three seconds the "Welcome" screen will switch to the set-up
screen as shown below. The following flow chart illustrates the installation and subsequent
steps after plug in.

4.1. Wizard Settings

Wizard will be use full to configure basic settings in the device like switch User account with
device name, management IP, And access Mode. The Wizard assisted interface covers the basic
requirements for most end-users to set up the Ethernet switch in these three steps; 1) Account; 2)
IP address; 3) Access Mode.
Step 1: Account Settings to configure user credentials to access the device which will guide
you the strength of security
19