Scanning With The Talkman A730/A730X Device - Honeywell Vocollect A700 Series Product Manual

Honeywell products, and their default options, have been measured and
qualified to ensure audio safety for common work flows and for the general
population. The default audio parameters should not be changed without
explicit direction from a qualified audio professional.

Scanning with the Talkman A730/A730x Device

See the Compliance Section of this document for Laser and Imager
Compliance and Precaution information.
The scanner can only be used at points in the task where it is allowed, such as a
check digit or product verification prompt.
1. Hold the Talkman A730/A730x in a "handshake" grip with the scanner
2. Position the device so that the scanner is 4 to 36 inches away from the bar
3. Press and hold the round black button to activate the scanner.
4. Direct the lighted aiming frame so that it completely contains the bar code.
5. When a scan is successful, the aiming frame will turn off and you will hear a
A700x Product Guide
CAUTION
There are a variety of parameters that can further increase output levels of
the Talkman device. Honeywell does not recommend changing any of these
settings in a way that increases sound output levels without consulting a
qualified audiologist. Changing these settings without qualified medical
supervision could result in additional hearding damage.
CAUTION
The scanner is designed for occasional use and should not be used more
than six times per hour. Other scanning devices more suited to hands-free
and eyes-free scanning should be used for optimum performance.
pointing away from you.
code you want to read. Note that scan accuracy may decrease at greater
distances.
beep in the headset.
NOTE
The beep that signals a scan is enabled by default but can be disabled
by setting EnableBeepOnBarcodeScan to 0. The beep volume is
28