Functional Description - Makita DLM330 Instruction Manual

FUNCTIONAL DESCRIPTION

Installing or removing battery cartridge
CAUTION:
Always switch off the machine before
installing or removing of the battery cartridge.
CAUTION:
Hold the machine and the battery
cartridge firmly when installing or removing bat-
tery cartridge. Failure to hold the machine and the
battery cartridge firmly may cause them to slip off
your hands and result in damage to the machine and
battery cartridge and a personal injury.
CAUTION:
Make sure that you lock the battery
cover before use. Otherwise, mud, dirt, or water may
cause damage to the product or the battery cartridge.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the machine, causing
injury to you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
CAUTION:
Hold the battery cover firmly when
installing or removing the battery cartridge.
To install the battery cartridge;
1. Open the battery cover while pressing the unlock button.
Fig.11
► 1 . Battery cover 2. Unlock button
2. Align the tongue on the battery cartridge with the
slot on the mower then slide the cartridge until it locks in
place with a little click.
Fig.12
► 1 . Battery cartridge
1 2
1
11 ENGLISH
3. Insert the lock key in the place shown in the figure
as far as it will go.
Fig.13
► 1 . Lock key
4.
Close the battery cover firmly.
To remove the battery cartridge from the mower;
1. Open the battery cover while pressing the unlock
button.
2. Pull out the battery cartridge from the mower while
sliding the button on the front of the cartridge.
3. Pull out the lock key.
4.
Close the battery cover.
Machine / battery protection system
The machine is equipped with a machine/battery
protection system. This system automatically cuts off
power to the motor to extend machine and battery life.
The machine will automatically stop during operation if
the machine or battery is placed under one of the fol-
lowing conditions.
Overload protection
When the machine/battery is operated in a manner
that causes it to draw an abnormally high current, the
machine automatically stops and the indicator lamp
lights up in red. In this situation, turn the machine off
and stop the application that caused the machine to
become overloaded. Then turn the machine on to
restart.
Overheat protection
When the machine is overheated, the machine stops
automatically and the indicator lamp lights up in red.
Let the machine cool down before turning the machine
on again.
Overdischarge protection
When the battery capacity becomes low, the machine
stops automatically and the indicator lamp lights up in
red. If the machine does not operate even when the
switches are operated, remove the battery from the
machine and charge the battery.
1