Age Time Settings; Cli Configuration; Web Configuration - Tripp Lite NGI-M08C4-L2 Owner's Manual

5.2.3.

Age Time Settings

5.2.3.1. CLI Configuration

Node Command
enable show mac-address-table
aging-time
enable configure terminal
configure mac-address-table aging-
time VALUE
Example:
L2SWITCH(config)#mac-address-table aging-time 200
Success!
L2SWITCH#show mac-address-table aging-time
The mac-address-table aging-time is 200 sec.

5.2.3.2. Web Configuration

Parameter
Age Time Setting
Age Time
Apply
Refresh
This command displays the current MAC address
table age time.
This command changes the node to configure node.
This command configures the mac table aging time.
The range is 20 to 500 or 0: disable.
Description
Configure the age time; the valid range is from 20 to 500 seconds. The
default value is 300 seconds. 0 means that the system will not age out
any entries.
Click Apply to take effect the settings.
Click Refresh to begin configuring this screen afresh.
50
Description