Cli Configuration - Tripp Lite NGI-M08C4-L2 Owner's Manual

6.3.1.1 CLI Configuration

Node Command
enable show port-isolation This command displays the current port isolation
enable configure terminal
configure interface IFNAME
interface port-isolation ports
PORTLISTS
interface no port-isolation
Example:
L2SWITCH(config)#interface 1/0/2
L2SWITCH(config-if)#port-isolation ports 3-10
Description
configurations.
"V" indicates the port's packets can be sent to that port.
"-" indicates the port's packets cannot be sent to that
port.
This command changes the node to configure node.
This command enters the interface configure node.
This command configures a port or a range of ports to
egress traffic from the specific port.
This command configures all ports to egress traffic from
the specific port.
103