Permanent Connection - Black & Decker BPWH84W Instruction Manual

SET UP & USE

PERMANENT CONNECTION

• Connect the ends of the water supply hose to the COLD faucet.
• Tighten the fittings by hand until they are snug, and then tighten them an additional
two-thirds of a turn with a wrench/pliers.
CAUTION: When you fasten the fitting, do not fasten it too tightly or apply
tape or sealant to the faucet or water supply inlet. This can damage the fitting.
After you have connected the water supply hose to the faucet, ensure that it is
connected securely by pulling the water supply hose downwards.
• Place the unconnected end of the hose into a bucket and open
the faucet connected to the water supply hose for 10 or 15
seconds to remove any foreign substances from the hose. Close
the faucet before continuing.
• Connect the end of the water supply
hose to the water supply inlet connection
at the top of the washer.
WARNING: The hose connected to the COLD water source must be connected
• Tighten the fitting by hand until it is snug, and then tighten them an additional
two-thirds of a turn with a wrench/pliers.
CAUTION: Confirm that the water supply hose is not twisted or bent. If the
• Turn on the COLD water supply and check all the water supply inlet connections
and the faucet for water leaks.
Step 4: Connect the drain hose
Insert the end of the drain hose into the drain
outlet located at the back of the unit. The other
end of the hose should be positioned using one
of the following methods:
A. Over the edge of a wash basin. Secure the guide
to the side of the basin wall with a hook or to the
tap with a piece of string to prevent the drain
hose from moving.
B. In a standpipe The standpipe must be no shorter
than 32 in. (81cm) and no longer than 39 in. (100cm).
C. In a laundry tub. The laundry tub must be no shorter
than 32 in. (81cm) and no higher than 39 in. (100cm).
WARNING: Make sure that the connection between
the drain hose and the wash basin, standpipe or
laundry tub is not airtight.
to the COLD water supply inlet.
hose is twisted or bent, the hose can leak and cause electric shock
due to the water leakage. To ensure correct water usage, connect
the COLD water faucet only.
Pull down on the white ring
to divide the adaptor into
Pull down on the white ring
two parts.
to divide the adaptor into
Top part: Faucet fitting
two parts.
Bottom part: Hose fitting
Top part: Faucet fitting
Bottom part: Hose fitting
Water Inlet
Connection
Laundry tub
39 in. Max
32 in. Min
Rubber gasket
Rubber gasket
Inner threads for oute
Inner threads for oute
Outer threads for inne
Outer threads for inne
Cold Water Source
Connection
Cold
Cold
Standpipe
Hose
retainer
39 in. Max
Tie
32 in. Min
strap
Page 19
Hose
retainer
Tie
strap