Using The Auxiliary Bus Control Block For Router Control - Sony MVS-6000 User Manual

2
To set the AUX delegation button shift operation
To set the operation mode of the rightmost button in the row of AUX
delegation buttons, select one of the following in the <Shift Mode> group of
the Panel >Aux Assign menu.
Hold: Acts as a shift button, and the shifted version of the AUX delegation
Lock: Acts as a shift button, and pressing the button toggles between the
Off: Acts as an AUX delegation button. In a 16-button system it acts as button
Using the Auxiliary Bus Control Block for Router
Control
To make router control settings, display the Setup >Panel >Aux Assign >RTR
Mode Setting menu.
Note
This setting is disabled for the CCP-9000/9000A.
To display the RTR Mode Setting menu
1
2
Assigning a destination to a destination selection button
In the Panel >Aux Assign >RTR Mode Setting menu, use the following
procedure.
88
Auxiliary Bus Control Block Settings (Aux Assign Menu)
M/E1 Utility, P/P Utility, Frame Memory Source1 and 2, Edit Preview, DSK1 to 4 Fill/
Source, M/E-1 Key 1 to 4 Fill/Source, M/E-1 EXT DME, P/P EXT DME, and CCR 1
and 2
• For a button for which you want to disable operation, press [Inhibit].
Press [Set] to confirm the selection.
buttons is enabled while the button is held down.
shifted version and the unshifted version of the AUX delegation buttons.
number 16, in a 24-button system as button number 24, and in a 32-button
system as button number 32.
In the Engineering Setup menu, select VF2 'Panel' and HF3 'Aux Assign.'
The Aux Assign menu appears.
Press [RTR Mode Setting].
The RTR Mode Setting menu appears. The left of the status area shows the
destination number assignment status and source table, and the right side
lists the destinations that can be assigned.