System Settings (System Config Menu); Specifying The Switcher Controlled By The Control Panel - Sony MVS-6000 User Manual

System Settings (System Config Menu)

Specify the overall system operation mode and the hierarchical relationship of
the devices.
To make the system settings, use the System >System Config menu.
To display the System Config menu
In the Engineering Setup menu, select VF1 'System' and HF2 'System
Config.'
Note
After changing any of the following settings, be sure to press [Execute] to save
the new values. If you want to cancel the setting changes without saving them,
press [Clear].

Specifying the Switcher Controlled by the Control Panel

1
In the System >System Config menu, press the [Panel Assign] button.
The Panel Assign menu appears.
2
Select the switcher to be controlled by the selected control panel, as
follows.
• If there is only one switcher on the network, in the <1st Switcher>
group, set [SWR1] to On, and in the <2nd Switcher> group, set [SWR2]
to Off.
• If there are two switchers on the same network, in the <1st Switcher>
group, select the switcher to be operated.
3
To set the selected control panel as tally control master panel, press [Tally
Master], turning it on.
If there are multiple panels and processors, the control panel for which
[Tally Master] is set to On carries out tally control for the whole system.
Note
When there are multiple control panels, make sure that one of them has
[Tally Master] set to On. When you change the master panel, be sure to
copy and save the setup tally (TLY) and router (RTR) data in the File
menu, and make the same settings for other panels.

System Settings (System Config Menu)

15