Honeywell ADEMCO VISTA-48D Installation And Setup Manual page 61

Table of Contents

Advertisement

S T A R T
S M T W T F S
0 0 1 0 0 0 0
H H M M A M
W A R N I N G D L Y T I M E
0 0
S T O P
S M T W T F S
0 0 1 0 0 0 0
H H M M A M
R E P E A T O P T I O N
0 - 4
X
R A N D O M I Z E
0 = N O 1 = Y E S
X
Start Time
01-12 (00-23)
= hour
00-59 = minute
0 = AM; 1 = PM (if applicable)
Days = place "1" under days
[∗] to continue
Warning Delay Time
01-15 = arm warning delay time
in minutes
[∗] to continue
Stop Time
01-12 (00-23)
= hour
00-59 = minute
0 = AM; 1 = PM (if applicable)
Days = place "1" under days
[∗] to continue
Repeat Option
0 = do not repeat
1 = repeat schedule weekly
2 = repeat schedule biweekly
(every other week)
3 = repeat schedule every third
week
4 = repeat schedule every fourth
week
[∗] to continue
Randomize
0 = no
1 = yes
[∗] to continue
Enter the event's start time and days of the week to occur.
To select days, position the cursor under the desired days using the
[∗] key to move forward, then press "1" to select the day(s).
† use 00-23 if 24-hour time is enabled.
This prompt appears if events "4 or 5" were selected.
Enter the desired amount of time the system should warn of
impending arming. The system will beep once every 30 seconds to
alert users that arming will soon occur. Otherwise, this prompt is
skipped.
Enter the event's stop time and days of the week to occur.
To select days, position the cursor under the desired days using the
[∗] key to move forward, then press "1" to select the day(s).
This entry applies only to the following events:
1 (relay on/off)
2 (user access)
3 (child-not-home report)
† use 00-23 if 24-hour time is enabled.
Enter the desired repeat option for this schedule.
e.g., To make a schedule that happens everyday you would select all
days with a repeat count of 1. To make a schedule that runs for one
week then stops, select everyday with a repeat count of 0.
If selected, the scheduled start and stop times will vary within 60
minutes of the "hour" time. For example, if a schedule is set to start at
6:15pm, it will do so the first time 6:15pm arrives, but on subsequent
days it will start anytime between 6:00 and 6:59 p.m.
NOTE: Do not use the random option if the start and stop times are
within the same "hour" setting, otherwise unpredictable results may
occur (e.g., the randomized stop time may occur before the start time).
5-19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents